Krups FNA1 Mode D'emploi page 13

• Raise the handle (f1) to eject the used
capsule which will automatically be collected
in the container (j). This container can hold a
maximum of 12 capsules. We advise you to
empty it at regular intervals.
Tips :
• Water quality is vital for a good espresso, so
we recommend that you use only fresh cold
water.
• Preheat the cups before making
espresso, as this will help it to retain its
temperature. A simple way to do this : first
fill the cups with hot water (see paragraph
«The Hot Water Function »).
. THE STEAM FUNCTION
You can use the steam function to:
. easily obtain milk with more or less froth to
make a cappuccino or a café crème,
. heating liquids.
Practical tips :
. Cappuccino : 1/3 coffee, 1/3 hot milk, 1/3
milk foam.
. Café crème : 1/2 coffee, 1/2 hot milk, not
too frothy.
1. Frothing milk
• For best results, make sure the cappuccino
accessory (h) is correctly positioned on the
end of the steam/hot water nozzle (g). This
accessory must only be used for foaming
milk.
• Fill the tank (a) with fresh water (1) and
position the switch (c) to «I». The
temperature indicator light (e) flashes
(green).
• Press the « » function button (d) : The
temperature indicator light (e) turns yellow
and flashes.
• Pour the desired quantity of skimmed or
semi-skimmed milk into a narrow jug which
will fit beneath the nozzle (g). Both the
milk and the jug should be nice and
cold.
Once the appliance reaches the correct
temperature, the temperature indicator light
(e) becomes fixed (yellow).
• Immerse the tip of the nozzle (g) in the milk
(4).
• Set the function selector (b) to the position
« ». The tip must not touch the bottom of
the container so as not to prevent the
passage of steam.
• Once you have obtained the foam, reset the
function selector (b) to the central position
and remove your jug.
• Immediately after use, remove the cappuc-
cino accessory (h) and clean the steam/hot
water nozzle (g) using a damp sponge. You
can also produce steam for a moment,
pointing the nozzle (g) towards the grille, in
order to eliminate any remaining trace of
milk.
2. Heating liquids
We advise you to remove the cappuccino
accessory (h).
• Fill the tank (a) with fresh water (1) and
position the switch (c) to «I». The
temperature indicator light (e) flashes
(green).
• Press the « » function button (d) : the
temperature indicator light (e) turns yellow
and flashes.
Once the appliance reaches the correct
temperature, the temperature indicator light
(e) becomes fixed (yellow).
• Then immerse the tip of the steam/hot water
nozzle (g) in the container holding the liquid
to be heated (5).
• Set the function selector (b) to the « »
setting. Once the liquid is hot, reset the
function selector (b) to the central position.
• For any liquid other than water, clean the
steam/hot water nozzle (g) immediately after
use with a damp sponge. You can also
produce steam for a moment, pointing the
nozzle (g) towards the grille, in order to
eliminate any remaining trace.
3. Important notes
Caution: during and after steam operation,
the nozzle (g) is very hot.
When you no longer wish to use the
steam function :
. press button (d) «
indicator light (e) turns green again and
flashes.
». The temperature e
13