VOLTCRAFT DSO-4062A Mode D'emploi page 4

Unpacking
Check all the parts for completeness and damage after unpacking.
Damages parts must not be used for safety reasons. In case of any damage
contact our customer service.
Setting up the Device
Set up the device, using the handle or the device's pedestal,l so it can be operated and read
comfortably.
Avoid direct sunlight over long periods, since it could damage the screen.
In order to comply with the technical tolerance data, the device has to be
operating for about 20 minutes within the given operating temperature
range.
Getting started
Connect the mains cable provided to the mains connector, at the back of the device, and con-
nect the Schuko plug to an earthed mains socket.
Switch on the device with the power switch (POWER I/0).
The device shows a start screen and is ready for operation after a short initialisation phase.
Connect the appropriate measuring cables/probes to the BNC connector of the input channel(s)
A or/and B.
The measuring voltage should only be applied to the internal conductor. The
external conductor (reference earth) is connected to the earth potential (pro-
tective earth conductor).
Touch the object to be measured with the probes.
To automatically set the signal, push the button „AUTOSET".
This function sets the time base, the vertical deflection and the trigger level automatically to
optimise the signal visualisation on the oscilloscope.
Remove the probe from the object, after finishing the measurement, and turn off the device.
Cleaning
Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed
(unless this can be done without tools).
Prior to cleaning or repairing of the device, all cables have to be detached
and the device has to be turned off.
Do not use scouring, chemical or aggressive cleaning agents such as benzene, alcohol or such
like. These might attack the surface of the device. Furthermore, the fumes are hazardous to
your health and are explosive. Moreover, you should not use sharp-edged tools, screwdrivers
or metal brushes or suchlike for cleaning.
For cleaning the device or the display and the measuring cables, use a clean, slightly damp,
fuzz-free, antistatic cloth.
Should questions arise concerning the use of the device, feel free to contact
our technical support at the following phone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15,
Phone 0180 / 586,582,723 8
Disposal
Electronic products are raw material and do not belong in the household waste.
When the device has reached the end of its service life, please dispose of it,
according to the current statutory requirements, at your local collecting site.
Disposal in the domestic waste is not permitted!
You thus fulfil the legal requirements and make your contribution to protecting the environment!
Impressum /legal notice in our operating instructions
These operating instructions are a publication by Voltcraft ® , Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 180/586 582 7 (www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2009 by Voltcraft ®