Dictator ADJUNKT Instructions D'installation page 4

INSTALLATION
1. Drill a suitably sized hole on the side of the door leaf to accommodate the tube of the spring
(E 16/2500: Ø 17; E 22/2550: Ø 23 mm).
2. Insert the concealed jamb closer into the hole and fix it with two countersunk head screws.
3. Fix the anchor plate to the frame exactly opposite and at the same height. Please make sure
there is enough space for the inserted chain links.
4. We recommend drilling a hole of approx. 50 – 80 mm depth and a slightly smaller diameter
than the width of the anchor plate.
5. Now connect the chain to the anchor plate on the door frame.
6. The jamb closer is now ready for operation.
Note
To increase spring force, open the door wide and secure the chain again with the securing
pin. Then shorten the chain by pushing it further through the anchor plate. After removing the
securing pin, the door will be closed with a higher force.
Please note that tensioning the closing spring on the concealed jamb closer too much and/or
with outside placed hinges could reduce the opening angle of the door. Continued opening of
the door to 180° could damage both the concealed jamb closer and the door.
Questions?
We'll be happy to help! Just contact us!
4
Installation instructions - Jamb door closer Adjunkt
DICTATOR Technik GmbH · +49 (0)821 246730 · info@dictator.de · en.dictator.de