Maintenance - Tineco PURE ONE S15 PRO Serie Mode D'emploi

Voice Prompt
(Contents may vary,
please in kind prevail.)
Status
Quick Start Guide
Connect to the
appliance
WiFi network
connected
WiFi network
disconnected
Voice prompts on
Voice prompts
disabled
Restore factory
settings
AUTO mode by
default
Switch to Manual
mode
Switch to MAX mode MAX Mode
Low battery
No battery, please
charge
Brush roller is
tangled
Dust sensor
malfunction
Reminder
Welcome to the
PURE ONE tutorial,
please follow the quick
start guide
This is the power button
The mode button and
power control slider are
on the top
The dust empty tab is on
the side of the dustbin
The filter is on the
bottom which is
removable for easy
cleaning
Please download Tineco
app and connect the
PURE ONE
Network connected
Disconnected
Voice prompts on
Voice prompts disabled
Factory settings restored
AUTO Mode
Manual Mode
Battery level is below
20%
Battery level is at 0,
please charge the
appliance
Brush roller tangled,
please clean the brush
Dust sensor malfunction,
please clean the dust on
the inner sensor
Status
Air channel blocked
Power is off
Start charging
Help Center

MAINTENANCE

Note:
• Clean the dustbin and filters after each use.
• To maintain high performance, wash and dry
the pre-filter monthly, replacing it every 6
months. Wash and dry the HEPA filter every 3
months, replacing it every 12 months.
Dustbin, Mesh Filter and
Pre-filter
1.Turn counter-clockwise to remove the filters.
Fig.E-1
2.Do not turn the appliance upside down when
removing or installing the filter to prevent dust
from entering the motor.
Fig.E-2
3.Clean the dustbin and mesh filter with a damp
cloth or the cleaning tool. Air dry completely
before reinstalling.
Fig.E-3
4.The pre-filter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-4
5.After cleaning, insert the pre-filter into the
mesh filter properly and it clicks into place.
Install the clean filters back into the main body,
then close the dustbin flap.
Fig.E-5
13
Reminder
Air channel blocked,
please clean the air
channel and dustbin
Power off
Charging
Cleaning tutorial
Voice switch
Connect to network
Restore factory settings
Exit