Breville the Juice Fountain Cold Manuel D'instructions page 12

Juice sprays out
from spout
Motor appears to
stall when overload
protection LED flashes
Overload protection
LED light flashing
during the use
Overload Protection
LED is on
If any of the above issues persist, or if you have questions, stop use of the juicer and contact
Breville Consumer Support.
12
•
The juice is being extracted too fast: try a slower juicing speed (if possible)
and push the food pusher down the feed chute more slowly.
•
Wet pulp can build up under the juicer cover and stall the juicer if the juicer is
used excessively without cleaning. If this occurs, disassemble and follow the
cleaning instructions to clean the filter bowl surround, the stainless steel filter
basket and the juicer cover. The juicer can also stall if excessive force is used
to push produce down the feed chute. If this occurs, ensure that a more gentle
pressure is used to push produce down the chute.
•
The juicer will automatically stop operating if either too much food is being
processed at one time or the pieces are not small enough. Try trimming the
food or cutting into smaller pieces of even size and processing a smaller
amount per batch. To continue juicing, reset the juicer by turning the juicer
OFF and back ON.
•
Allow the motor to reach full speed before putting ingredients in the chute.
Pressing ingredients down before the juicer reaches full speed can cause the
motor to stall or overload. Use gentle to moderate pressure on the pusher.
Lower pressure produces a better juice yield.
•
Hard fruit and vegetables will put excess strain onto the motor if a low speed
is selected. Refer to the juicing guide to determine the correct speed for the
fruit and vegetables selected for juicing.
•
This indicates the motor speed is slowed down to a not-efficient level. This
may be caused by too heavy pushing force on the pusher or too much pulps
sticking onto the lid or in pulp pin. Using proper pushing force on the food
pusher or regularly clean the lid and pulp bin can prevent this situation to
happen.
•
This indicates motor overload protection is activated. To reset the unit, unplug
the unit from power and let the motor cool down for 10 to 15 minutes, and
plug the power on again.