Forgeries/Non-Approved Parts; Fundamental Hazard Potential; Safety During Commissioning, Operation, Maintenance And Inspection; Owner's Responsibility - ACO Lipumax Serie Instructions De Service Et De Maintenance

2.3

Forgeries/Non-approved Parts

The plant underwent a comprehensive
set of product tests before it was laun-
ched, and all components were tested at
maximum load. Recently, there has been
a substantial increase in the number of
imitations of high-quality spares. Installing
2.4

Fundamental Hazard Potential

Contact with greasy water, e.g. during
maintenance work, can lead to infections.
2.5

Safety during Commissioning, Operation, Maintenance and Inspection

During commissioning, operation, mainte-
nance and inspection, the following risks
must be assumed:
Beware
The following safety instructions must be
read carefully before starting commissi-
oning and operation. If they are ignored,
minor and moderate injuries may occur.
Ensure staff have the necessary qualifica-
tions. Contact with greasy waste water.
Skin and eye injuries, risk of infection!
Personal protective equipment must be
worn, Chap. 2.3.
On contact with skin: Relevant skin
areas must be washed thoroughly with
soap then disinfected.
On contact with eyes: Rinse eyes.
If eyes continue to water, consult a
doctor
2.6

Owner's Responsibility

It is the responsibility of the owner to en-
sure the following points are respected:
The plant must only be used as intend-
ed and if in good operating condition,
Chap. 2.1
Nothing must impede the correct func-
tioning of the safety devices.
Servicing timetables must be adhered
to and faults dealt with swiftly. Owners
should only tackle faults themselves if
the relevant measures are described in
Operating and maintenance instructions
non-approved parts can threaten safety
and voids any guarantee from ACO. Only
original parts from ACO, or ACO-approved
spares, may be used when replacing com-
ponents.
Danger
Never climb into the manhole without
backup (a second person to assist you)
and until a clearance measurement (oxy-
gen content) has been performed. Only
people with the necessary qualifications
are permitted to climb into the separator
once it has been installed (and only if
necessary). If climbing inside, make sure
you have a secure footing. Do not stand
or climb on components. This is a dange-
rous situation which, if not prevented, will
lead to death or serious injuries.
these operating instructions. ACO Ser-
vice is responsible for all other tasks.
Do not remove the plant type plate
and make sure that it remains legible,
Chap. 3.2.
Any necessary personal protective
equipment (PPE) must be provided in
sufficient quantities and must also be
worn,
Chap. 2.2.
A full set of operating instructions must
be provided at the place of use in a
legible form and employees must be
trained in them accordingly.
Only use qualified and authorised staff,
Chap. 2.5.
19