Optional Wireless Connection - Martin Logan BalancedForce 210 Manuel De L'utilisateur

Masquer les pouces

Table des Matières

Les langues disponibles

2 Connect the Multi Out of the subwoofer to LFE In / Multi In of

the next subwoofer. Use a quality RCA interconnect.

WARNING! Never connect the the subwoofer's

Multi-Out to the input of an amplifier connected to

a full-range speaker. The encoded signal from the

Multi-Out contains high-frequency information that

may potentially damage tweeters.

3 Repeat step 2 for each additional subwoofer in the chain.

Recommended Control Settings:

1 For the first subwoofer in the chain, adjust the control set-

tings using the procedure described for the connection

method used (e.g. 2-Channel Mode, Multi-Channel Mode, or

Simultaneous 2-Channel/Mulit-Channel Mode).

If you are using a custom low-pass filter, load the custom low-

pass only on the first subwoofer. There is no need to load this

filter on additional subs.

If you are using PBK room correction, after connecting all of

the subs, attach the PBK system to the first sub and run PBK as

you would if you were only measuring one subwoofer.

2 The Level, 25Hz Level, Low-Pass Filter, and Phase settings

for additional subwoofer will no longer function. The Tone

Sweep, Room EQ, and Custom Low Pass buttons will also no

longer function. The Mode control on additional subs must be

set to 'Auto (Trigger)' to allow the power status of additional

subwoofers to synchronize with the first subwoofer.

Regardless of how you use your sub, experimentation often

results in better sound. Don't be afraid to try different settings.

You can always return the controls to their previous settings.