Troubleshooting - ALM EarthWise 65821 Manuel De L'utilisateur

Problem
Handle not in position
Mower not starting.
Mower cutting grass
unevenly.
Mower not mulching
properly.
Mower hard to push.
Mower vibrating at higher
speed.
SERVICE
For parts or service, contact your nearest EarthWise authorized service dealer. Be sure to provide all
relevant information when you call or visit. For the location of the authorized service dealer nearest you,
please call 1-800-313-5111or visit us online at www.americanlawnmower.com.
REPAIR PARTS
The model number of this tool is found on a plate or label attached to the housing. Please record the serial
number in the space provided below.
MODEL NUMBER
SERIAL NUMBER___________

TROUBLESHOOTING

Possible cause
Carriage bolts not seated properly.
Handle knobs not tightened.
Battery is not fully inserted in mower.
Battery is low in charge
Battery is either defective or will not take
a charge.
Switch is defective.
Grass jammed between deck and blade.
Lawn is rough or uneven.
Cutting height is not set properly.
Wet grass clippings sticking to the
underside of the deck.
Mulching plug is missing.
High grass, rear of mower housing and
blade dragging in heavy grass, or cutting
height too low.
The rear of the grass catcher is dragging
in thick grass.
Blade is unbalanced.
Bent motor shaft.
65821
Adjust the height of the handle and make
sure the carriage bolts are seated properly.
Tighten handle knobs.
Check the connection between battery and
mower. Make sure battery clicks into place.
Charge the battery.
Replace the battery.
Replace the switch.
Remove battery. Check under deck for jams.
Check mowing area.
Move the wheels to a higher setting.
Wait until the grass dries before mowing.
Install the mulching plug.
Raise cutting height.
Empty grass clippings from the grass catcher.
Balance the blade by grinding each cutting
edge equally.
Stop the motor, remove battery, and inspect
for damage. Have repaired by an authorized
service center before restarting.
16
Solution