Troubleshooting - ALM EarthWise 60420 Manuel De L'utilisateur

Problem
Handle not in position
Mower not starting.
Mower cutting grass
unevenly.
Mower not mulching properly. Wet grass clippings sticking to the
Mower hard to push.
Mower vibrating at higher
speed.

TROUBLESHOOTING

Possible cause
Carriage bolts not seated properly.
Handle knobs not tightened.
Battery is low in charge
Battery is either defective or will not
take a charge.
Lawn is rough or uneven or cutting
height not set properly.
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Blade is unbalanced.
Bent motor shaft.
For any questions about operating or maintaining your product,
call the Earthwise™ Help Line! 1-800-377-5888 (USA) 1-800-561-0004 (CAN)
Your product has been fully tested prior to shipment to ensure your complete satisfaction.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Tighten handle knobs.
Charge the Battery.
Replace the battery.
Move the wheels to a higher po-
sition.
Wait until the grass dries before
mowing.
Raise cutting height.
Balance the blade by grinding
each cutting edge equally.
Stop the motor, remove battery,
and inspect for damage. Have
repaired by an authorized service
center before restarting.
CALL US FIRST
20
Solution