Publicité
Les langues disponibles
Les langues disponibles
5.2 Filling the tank
Attention: The maximum water level corresponds to the overflow hole situated near the end of water load pipe. The unit
is fitted with a pressure switch and the elements cannot be turned on until the water level is over the elements and about
half way up the tank.
Close the water drainage tap
position
5.3 Switching on the pasta cooker heater
Fill the tank with water as detailed, using the selector knob – the green neon is illuminated.
Turning the heater control to 5 turns the element on continuously and amber neon illuminates. When the water is
boiling, turn the control down. The unit is now ready to cook.
5.4 Switching off the pasta cooker
Turn both control knobs to the 'Off' position. The neon indicators will extinguish. Switch off at the mains supply.
5.5 Emptying the tank
Open the tank water drainage tap and drain into either a suitable receptacle or a floor drain.
6 CARE AND MAINTENANCE
•
Do not use a water jet or steam cleaner and do not immerse this appliance.
•
Always disconnect the appliance from the power supply before cleaning or maintenance.
•
Steel parts can be cleaned using a cloth with water and mild detergent – aggressive or abrasive cleaning substances
such as steel wool or chlorine based products must be avoided.
•
Do not use sharp objects during cleaning.
•
If the appliance is not to be used for a lengthy period, disconnect from the mains supply and clean well.
•
All servicing, maintenance and component replacement must be carried out by qualified personnel.
•
Please note that to assist in cleaning the tank, the element in the pasta boilers may be lifted out of the tank.
Fill the tank with water by turning the selector knob to this position
Once the level of the overflow hole has been reached, turn the knob to this position
In order to add a low flow of water, during cooking, turn the knob to this
Publicité
