Publicité
Les langues disponibles
Les langues disponibles
The frame supplied should be welded to the hobtop and sealed with silicone sealant to make it water-proof (see
picture below). The drain cutout detail is for the base of the unit.
4.2.2 Pressure switch
There is a pressure switch supplied that forms part of the interlock circuit and this should be mounted to the
chassis above the metal pressure pipe to prevent water getting trapped in the silicone pipe.
4.2.3 Control panel
The control panel may be either fitted on the supplied metal panel to a cutout as shown below or the components
can be mounted direct to the fascia plate.
Connect the tank drain to a suitable drain observing local water regulations.
4.23 Inlet solenoid
The inlet solenoid is supplied with a mounting plate. The cutout required for it is shown below. The inlet connector
is ¾" BSP
Publicité
