Cleaning; Malfunctions; Shutting Your Appliance Down - Electrolux EK260BR Notice D'utilisation

Cleaning

Before cleaning, always switch off the appliance. Discon-
nect from the mains or switch off the fuse!
• Clean the inside and equipment parts with lukewarm water and
a little detergent. Do not use chemical solvents or any cleaning
agents containing sand or acid.
• Ensure that no cleaning water penetrates
into the electrical components or ventilation
grille.
• Dry all parts well with a cloth.
• Clean the drain hole in the refrigerator
compartment with a thin object, e.g.
cotton swab or the like.
• Do not damage or remove the type plate
on the inside of the appliance. It is very
important for servicing purposes.
CAUTION
Risk of damage to the appliance components
and risk of injury due to hot steam.
Do not use steam cleaning equipment to clean
the appliance.
58

Malfunctions

• F0, F1, F2, F3, F4, F5, F6, F7, F8 or F9 appears in the display.
– The appliance has suffered a fault.
Contact the customer service department.
• When inserting the mains plug, the refrigeration unit does
not switch on, but a value is shown in the temperature
display.
– Demo mode is activated.
Contact the customer service department.
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects
to vibrate? Please note that noises caused by the refrigerant
circuit cannot be avoided.
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the tempera-
ture")?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes apply
and you cannot rectify the fault
yourself, contact the nearest
customer service department
stating the type designation
PNC number and appliance
2
number as indicated on the
3
type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
,
1