Care And Cleaning; General; Odor Removal; Adhesives - Amana SCD22TBL Mode D'emploi

Care and Cleaning

WARNING
To avoid electrical shock which can cause
severe personal injury or death, disconnect
power to refrigerator before cleaning. After
cleaning, connect power.
Caution
To avoid personal injury or property damage,
read and follow all cleaning product
manufacturer's directions.

General

1. Wash surfaces with 4 tablespoons baking soda
dissolved in 1 quart warm water and a soft, clean
cloth.
2. Rinse surfaces with warm water. Dry surfaces with a
soft, clean cloth.
• Do not use the following items:
- abrasive or harsh cleaners, ammonia, chlorine
bleach, etc.
- concentrated detergents or solvents
- metal scouring pads
These items can scratch, crack and discolor
surfaces.
• Do not place buckets, shelves, etc. in dishwasher.

Odor Removal

1. Remove all food and disconnect power to
refrigerator.
2. Clean all interior surfaces including ceiling, floor,
and walls according to "General" instructions. Pay
special attention to corners, crevices, and grooves.
Include all drawers, shelves, and gaskets.
3. Connect power to refrigerator and return food to
refrigerator. Wash and dry all bottles, containers and
jars. Wrap foods in tightly sealed containers to
prevent further odor. After 24 hours, check if odor
was eliminated.
Complete the following steps if odor was not eliminated.
4. Complete steps 1-2.
5. Place garden fresh crispers on top shelf of Fresh
Food section. Pack Fresh Food and Deepfreeze
sections including doors with crumpled sheets of
black and white newspaper.
6. Place charcoal briquettes randomly throughout
newspaper.
7. Close doors and let stand 24-48 hours.
8. Remove charcoal briquettes and newspapers.
9. Complete steps 2-3.
Contact Consumer Affairs Department if odor was still
not eliminated.

Adhesives

1. Remove glue residue by rubbing toothpaste into
adhesive with fingers until adhesive loosens.
2. Rinse surface with warm water. Dry surface with a
soft, clean cloth.

Door Gaskets

1. Clean door gaskets every 3 months according to
"General" instructions.
2. Apply a light film of petroleum jelly to keep gaskets
pliable.

Condenser Coils

Clean condenser coil every 3 months to ensure
maximum performance of refrigerator. Accumulated
dust and lint may cause the following:
• reduced cooling performance
• increased energy usage
• premature compressor failure
1. Remove toe grille by holding ends and pulling
forward.
2. Clean front surface of condenser coil with a vacuum
cleaner hose nozzle.
3. Replace toe grille by inserting clips in holes and
snapping in.
Caution
To avoid property damage, protect soft vinyl
or other flooring with cardboard, rugs, or
other protective material.
4. Pull refrigerator away from wall. Run a vacuum
brush across condenser fan outlet grille on back
of refrigerator.
®
13