Amana SCD22TBL Mode D'emploi page 5

3. Turn on water supply to refrigerator and check for
leaks. Correct any leaks.
WARNING
To avoid electrical shock which can cause severe
personal injury or death, all back covers must be
installed before connecting power to refrigerator.
4. Replace lower back cover screws and black plastic
spacer.
5. Create service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator
cabinet with a "P" clamp. Copper tubing must
not extend 3/8" (9 mm) beyond back.
"P" clamp
Copper
tubing
3/8"
(9mm maximum)
Black plastic spacer
3. Plug in power cord.
4. Move refrigerator into final location.
5. Level refrigerator and align doors.
a. Remove toe grille.
b. Turn roller adjustment screw to raise or lower
refrigerator cabinet until refrigerator is stable.
Some models have both front and rear adjustable
rollers.
c. Models with Hinge Adjusting Cam
If tops of doors are not aligned after leveling,
loosen refrigerator door hinge screws 1/2 turn.
Turn cam clockwise 1 increment at a time until
doors are aligned. Open and close doors. Tighten
hinge screws.
Rear roller
adjustment screw
(some models)
Front roller
adjustment screw
6. Review "Installation Checklist" in
Owner's Manual with consumer.
5
Hinge adjusting
cam (some
models)