Publicité
Les langues disponibles
Les langues disponibles
30. USE ExTRA SUPPORTS
(tables, saw horses, blocks, etc.) for any workpiece large enough to tip
when not held down to the bench top.
31. NEVER USE ANOTHER PERSON AS A SUBSTITUTE FOR A TABLE
ExTENSION
or as additional support for a workpiece that is longer or wider than the
basic sander table or to help feed, support or pull the workpiece.
32. WHEN FINISHINg ON THE DISC, ALWAYS PRESS THE
WORkPIECE AgAINST THE "DOWN" SIDE OF THE DISC.
sanding against the side coming up from under the work table could
damage the work by making it "chatter" or it could tear it from your
hands and throw it.
33. SAND ONLY ONE WORkPIECE
at a time.
34. BEFORE STARTINg YOUR WORk WATCH THE SANDER WHILE
IT RUNS.
• if it makes an unfamiliar noise or vibrates a lot, stop immediately.
• Make sure the sanding disc turns counter-clockwise. if not, stop
immediately.
• turn the sander off. unplug the sander. Do not restart until the
problem is found and rectified.
35. AVOID AWkWARD OPERATIONS AND HAND POSITIONS.
a sudden slip could cause a hand to move into the abrasive disc or
belt. Keep fingers away from where the belt goes into the dust trap.
36. SUPPORT THE WORkPIECE FIRMLY
with a miter gauge, backstop or work table when sanding with a belt.
Hold the workpiece firmly. Loss of control of the workpiece can result in
injury.
37. AVOID kICkBACk BY SANDINg IN ACCORDANCE WITH THE
DIRECTIONAL ARROWS ON THE MACHINE.
Feed the workpiece against the downward rotation side of the disc or
against the forward rotation of the belt. Loss of control of the workpiece
can result in injury.
38. DO NOT PERFORM LAYOUT, ASSEMBLY OR SET-UP WORk ON
THE TABLE
or work area when the machine is running. a sudden slip could cause a
hand to move into the abrasive surface. severe injury can result.
39. DISCONNECT THE UNIT FROM THE POWER SUPPLY,
turn the switch off and remove the safety switch key when not in use,
before servicing or adjustment and when changing the abrasive disc or
belt.
40. TURN THE MACHINE OFF,
disconnect the machine from the power source and clean the table /
work area before leaving the machine.
41. LOCk THE SWITCH IN THE "OFF" POSITION TO PREVENT
UNAUTHORIzED USE.
someone else might accidentally start the machine and cause injury to
themselves.
42. kEEP THESE INSTRUCTIONS.
refer to them frequently and use them to instruct other users. if you
lend someone this unit, also lend them the instructions.
43. FAILURE TO FOLLOW OPERATINg INSTRUCTIONS AND SAFETY
PRECAUTIONS IN THIS INSTRUCTION MANUAL CAN RESULT IN
SERIOUS INjURY.
read the manual before starting or operating this unit.
44. FOLLOW ALL LOCALLY APPLICABLE WIRINg CODES AND
RECOMMENDED ELECTRICAL CONNECTIONS TO PREVENT
SHOCk OR ELECTROCUTION.
8
Publicité
