General International BD7004 Mode D'emploi page 13

INSTALLINg THE BACk STOP
1. Locate the back stop (I, fig.8) and the M6 x 1.0-14 hex head screw (b,
fig.8), lockwasher (c, fig.8) and flat washer (d, fig.8).
2. Hold the back stop in position and fasten with a wrench (e, fig.8) as
shown. Do not over tighten.
INSTALLINg THE WORk TABLE ASSEMBLY
1. Locate the work table support bracket (f, fig.9) and, from the bag of
loose parts, three M6 x 1.0-14 hex head screws (b, fig.9), flat washers
(c, fig.9) and lockwashers (d, fig.9).
2. Position the work table support bracket against the underside of the
work table, aligning the holes as shown.
3. Fasten the work table support bracket to the work table with the screws
and washers as shown.
4. Locate the 1/4" x 11/16" x 0.6" (6.5 x 17.8 x 1.6 mm) washer (c, fig.10)
and the work table lock knob (N, fig.10) among the the bag of loose
parts.
5. Position the work table support bracket (f, fig.10) against the
corresponding holes on the left side of the base as shown. Make sure
the 9.5 mm (~3/8 in.) diameter index pin (g, fig.10) aligns with the upper
hole (h, fig.10).
6. Place the washer on the threaded shaft of the knob and insert the shaft
through the slot in the support into the threaded hole (j, fig.10) in the
base.
wARNING! To avoid trapping the workpiece or your fingertips between
the table (L, fig.11) and the sanding surface (V, fig.11), the table edge
should be a maximum of 1/16 inch (1.5 mm) from the sanding surface.
7. Loosen the three hex screws (b, fig.11), that hold the work table to the
work table support bracket and adjust the table.
150311
13