General International BD7004 Mode D'emploi page 20

INSTALLATION AND ADjUSTMENT
3. Loosen the three screws (z, fig.31) to allow the pulleys to shift enough
to place the belt around them.
4. Place the new drive belt (bb, fig.31) around the motor pulley (aa, fig.31)
and the drive pulley (cc, fig.31) as shown.
5. slightly tighten the three screws.
6. Adjust belt tension by putting a slot screwdriver blade (dd, fig.32) in the
adjusting hole (ee, fig.32).
7. Push up on the screwdriver to increase the tension between the pulleys.
8. Fully tighten the three screws, being careful not to disturb the belt.
9. Test belt tension by placing fingers on either side of the belt and
squeezing the two sides together at the mid-point between the pulleys
(ff, fig.33). there should be about 1/4" (6 mm) of give to the belt.
NOTE: Excessive tightness on the drive belt may cause increased
noise and also overload the motor. Excessive belt looseness may cause
it to fail prematurely.
COVER REPLACEMENT
10. Locate the drive belt cover and position it inside it inside the relief
edges of the drive belt housing.
11. Using a Phillips screwdriver, re-install and tighten the flat head screw.
Do not over-tighten.
20