General International BD7004 Mode D'emploi page 14

8. Use your Operator's Manual (k, fig.12) as a spacer. Place ten pages of
this manual between the sandpaper disc and and the edge of the table.
9. Hold the table (L, fig.12) against the manual and tighten the three hex
head screws.
MOUNTINg THE TABLE FOR VERTICAL BELT SANDINg
1. Remove back stop bolt {the M6 x 1.0 - 14 hex head screw (b, fig.8),
lockwasher (c, fig.8) and flat washer (d, fig.8)} and back stop.
2. remove the work table assembly from the disc sander side by
unscrewing the work table lock knob and washer.
NOTE: The belt sanding bed may be raised to the vertical position by
loosening the hex socket head screw and then pushing the belt bed into
the vertical position. See Positioning the Belt Bed, below.
3. attach the table assembly to the auxiliary holes (G, fig.13) in the back
side of belt bed. Make sure the index pin (g, fig.13) goes into the upper
hole when the belt sanding bed is in the vertical position.
SQUARINg THE WORk TABLE
wARNING! To avoid injury from an accidental start, make sure the tool
is unplugged before any alignment is attempted.
1. using a combination square (l, fig.14), check the angle between the
work table (L, fig.14) and the sanding disc (V, fig.14).
NOTE: The combination square must be accurate. Please check it if in
doubt.
2. if the table is not at 90º to the disc, loosen the work table lock knob (N,
fig.14) and tilt the table.
3. adjust the table to be exactly square to the disc and re-tighten the work
table lock knob.
4. attach the table angle scale label (m, fig.14) to indicate 0º on the dust
guard.
INSTALLINg THE SANDINg BELT
TENSIONINg
wARNING! To avoid injury from an accidental start, turn the switch to
Off, remove the switch safety key and remove the plug from the power
source before removing or installing a sanding belt.
14