Rollei Profi Funk-Sender Instructions page 64

Nikon master control Multi mode
64
2 . If the mode is chosen, press the left and right button to set the flash power
which is available from 1/4 to 1/128 (in total 6 levels) .
3 . Press the OK button repeatedly until the frequency number is highlighted . Press
the left and right button to set the flash frequency from 1 – 100 Hz .
4 . Press the OK button repeatedly until the number of flashes is highlighted . Press
the left and right button to set the times of flashes from 1 – 40 .
Group A Flash power & Flash frequency connection table
Flash power
Flash frequency
5 . After the parameters have been set, press shortly the group buttons A, B, C to
select the group and to exit the group setting .
6 . After the group settings have been done,
press the mode button to turn on or off the
selected group . You can also press the left
or right button to turn the groups on or off .
Press the up and down button to adjust the
zoom setting (focal distance) of each group .
7 . After the settings have been done, press the group buttons A/B/C/D again to exit
the setting and sent the information to the other flash units . Please note all the
flash units need to have the same channel .
ENGLISH
1/128 1/64
1–40 1–20
1/32 1/16
1–12 1–8
1/8 1/4
1–4 1–2