Rollei Profi Funk-Sender Instructions page 62

Nikon master control mixed mode
62
3 . After you have selected the group press the mode button to set the flash mode
for this group . The mode parameters are as follows:
TTL: The exposure compensation can be set from -3,0EV to +3,0EV . In total you
have 22 levels . Press the left and right button to change the exposure compen-
sation . Press the up and down button to adjust the zoom settings
(focal distance) .
M: In the manual mode the flash output can be set from 1/128 to 1/1 . With the
left and right buttons the values can be increased or decreased by 0,3 EV
(in total 22 levels) . Press the up and down button to adjust the zoom settings
(focal distance) .
OFF: If the group is turned off, it will not flash .
4 . After the group parameters are finished press again the corresponding group
button (A, B, C, D) to exit the settings and set the flash units all to the same
channel as the trigger . The group power can be adjusted individually for each
group . But if the flashes of all three groups should fire at the same time, they
need to be in the same channel .
• Under this mode you can set for three groups different modes and power
outputs .
ENGLISH