Rollei Profi Funk-Sender Instructions page 59

Canon master control Multi mode
If the flash ratio off is chosen that means that all flash groups have the same
power output . If the ratio A:B is selected the groups A and B are enabled and
the power of both groups can be set individually . If the ratio A:B:C is selected all
groups are enabled and the power of each group can be set individually .
3 . Press the OK button repeatedly until the frequency number is highlighted . Press
the left and right button to set the flash frequency from 1 – 199 Hz .
4 . Strobe flash
Press the OK button repeatedly until the number of flashes is highlighted .
Press the left and right button to change the value (influenced by the power of
group A) .
Group A Flash power & Flash frequency connection table
Flash power
Flash times
1/128 1/64
1–40 1–20
1/32 1/16
1–12 1–8
1/8 1/4
1–4 1–2
59