Rollei Profi Funk-Sender Instructions page 50

Canon master control TTL mode
50
If the flash ratio is disabled (ALL) this means that all flash units of the three
groups will have the same output in brightness, exposure compensation and
surrounded exposure. If the flash ratio A:B is selected that means that the flashes
of group A and B will flash in the same power output. And if the ratio A:B:C is
selected that means that all flashes of the three groups will flash, the groups A
and B will have the output brightness and group C is the power exposure.
3) P ress the OK button repeatedly until the flash ratio number is indicated with
an arrow. Press the left and right button to set the flash ratio.
4) I f the flash ratio is A:B:C press the OK button repeatedly until the group C is
indicated with the arrow. Press the left and right button to set the exposure
compensation.
• If the flash ratio A:B is selected the flash units of group C won't flash.
• If the flash units of group C are positioned towards the subject, the subject
will be overexposed.
ENGLISH