LaserLiner SensoLite 100 Mode D'emploi page 6

Insert battery
In order to preserve the battery life, the
receiver switches off automatically if it is
not used for around 5 minutes.
Working with the laser receiver
Set the rotary laser to maximum speed and switch the laser receiver on.
It is able to detect the laser beam at a great distance now. Move the
SensoLite up and down through the laser beam until the middle indicator (2)
appears. Mark the measured height at the perimeter marking groove.
Rapid peeping
The laser receiver has two tolerance settings:
– Yellow LED = Free-hand range: Display with larger tolerance for
!
rough alignment by hand.
– Green LED = Precision range: Display with smaller tolerance for preci-
sion alignment (e.g. levelling staff).
06
GB
Laser
Continuous tone =
mark the reference
–
+
Rapid peeping