Switching The Lights On/Off; Walk-Assist Mode; Information Of The Head Unit - Led - MAHLE X20 Mode D'emploi

3.4. Switching the lights ON/OFF

If the lights on your eBike are connected to the X20
System you can control them using the HMI Head Control
Unit. Please ensure that the used lights are compatible
and a MAHLE compatible remote is used to activate or
deactivate the light system too.
There are two main modes to control the lights:
• Automatic Mode: with the Ambient Light Sensor and
according to environmental conditions the Head Unit
will activate/deactivate the lights accordingly.
• Manual Mode: user can take control of activating the
lights at any time, either via ANT+ LEV display or via
e-Shifters when installed.
NOTICE
The eBike manufacturer could establish an additional
automatic mode based on the switching ON/OFF of the
eBike.
Switching the lights ON
Press the LEFT button of the e-Shifter long to switch the
lights on. A "switching lights on" animation can be seen
on the LED bar. If everything is ok the LED bar will turn
back to the battery status.
Yellow color outer animation when switching ON the
lights
Switching the lights OFF
Press the LEFT button of the e-Shifter long to switch the
lights off again A "switching lights off" animation can be
seen on the LED bar. If everything is ok the LED bar will
turn back to the battery status.
Yellow color inner animation when switching OFF the
lights
NOTICE
The functionality of the LEFT and RIGHT button can be
changed by the manufacturer. Please check the manual
of your specific model for detailed information. Pressing
the button for longer can control both walk assist and the
lights. In accordance with particular regulations, the OEM
can setup the status lights of the eBike upon system
start.

3.5. Walk-assist Mode

To use the walk-assist mode, an additional remote
e-Shifter accessory is required.
To activate the walk assist you need to hold the right
button of the e-Shifter pressed down. Be aware that the
bicycle manufacturer can
functionality of the e-Shifters. The maximum speed
during walk-assist is 6 km/h (Approximately 10 miles). If
exceeded the walk assist will automatically shut off. The
walk-assist will also shut off when you release the button.
The color of the current assist level will be displayed at
50% of the LED bar, when the walk mode is active. This
will be visible while the mode is active.
NOTICE
Remember than the walk assist mode should only be
used when walking the bike. The wheels need to be in
contact with the ground to prevent injuries.

3.6. Information of the Head Unit - LED

The Head Control Unit permanently will inform you about
the two most important parameters:
• SOC, State of Charge of the battery
• Active Assist Level
Control Button
RGB Dynamic Line
013
always customize the
Ambient light sensor
Set screw