Install Range Hood - Elica ASTI Guide D'utilisation, D'entretien Et D'installation

Bracket Orientation for 30" (76�2 cm) Cabinet
C
A
B
D
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C. Washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm cabinet)

Install Range Hood

I WARNING
EXCESSIVE WEIGHT HAZARD�
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
RANGE HOOD�FAILURE TO DO SO CAN RESULT IN BACK OR
OTHER INJURY�
1 Using 2 or more people, lift the hood liner into its moun-
ted location� Attach with four 4�2 x 19 mm screws into the
slotted openings� Do not tighten screws�
2 Center the canopy in the cabinet� Align the bottom of the
canopy with the bottom of the cabinet� Install four 4�2 x 19
mm screws into the hood canopy assembly and tighten all
(8) mounting screws�
A
A. Cabinet
B. Hood liner canopy assembly
3 Remove the metal grease filters from the face panel�
4 Connect the lamps connector to the connector present
inside the hood as shown in drawing�
A. Lamp connector
B. Hood connector
10
C
B
C. Screws - 4.2 x 19 mm (8)
A
B
3
Install the vent system according to the method needed�
Use caulking to seal the exterior wall or roof opening�
5
Attach the face plate to the hood insert� Tighten to secure�
NOTE: If cabinet depth is greater than 12", it is recommended
that the two ⁄ " metal spacers are installed�
1
2
Install to front and rear sides of the face plate with 3�5 x 9�5 mm
screws as shown in drawing�
A. Face Panel
B. Front and rear spacer
A. Screws - 3.5 x 9.5 mm flat-head (4)
B. Face plate (30" x 12"[76.2 cm x 30.5 cm] shown)
C. Cabinet (30" x 12" [76.2 cm x 30.5 cm] shown)
Move the bracket ⁄ " (1 cm) from
6
1 6
the bottom side of the cabinet
C. Screws - 3.5 x 9.5 mm (4)