Care & Maintenance - Danby DFF121C1WDBL Manuel Du Propriétaire

CARE & MAINTENANCE
CLEANING
• To clean the inside of the appliance, use a soft
cloth and a solution made of a tablespoon of
baking soda to one quart of water or some mild
detergent.
• Wash removable shelves in a mild detergent
solution, then dry and wipe with a soft cloth.
• Clean the outside with a soft, damp cloth and
some mild detergent.
• It is important to keep the area clean where the
door seals against the cabinet. Clean this area
with a soapy cloth. Rinse with a damp cloth and
let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
door is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the refrigerator if operation has been
interrupted.
DEFROST
This appliance is equipped with an automatic
defrost function and does not require manual
defrosting. Defrost water from the appliance
is channeled into a drip tray located near the
compressor. Heat transfer from the compressor
causes the defrost water to evaporate.
VACATION
• Short vacations: Leave the appliance operating
during vacations of less than three weeks.
• Long vacations: If the appliance will not be used
for several months, remove all items and turn
off the appliance. Clean and dry the interior
thoroughly. To prevent odor and mold growth,
prop the door open.
MOVING
• Remove all items.
• Use tape to secure the shelves inside the
appliance.
• Turn the adjustable leg up to the base to avoid
damage.
• Tape the door shut.
• Protect the outside of the appliance with a
blanket or similar item.
• Be sure the appliance stays in the upright
position during transportation. If the appliance is
placed on its back or side during transportation,
upon reaching the destination, allow it to remain
upright for 6 hours before plugging in to avoid
damage to internal components.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce.
6