AL-KO Solo BF 5002-R I Mode D'emploi page 15

Combi BF 5002-R I
Activating the drive mechanism for:
Cutter bar
„
Front rotary mower
„
1. Swing safety bar out of the way. (Fig. 9 - 3)
2. Push clutch lever fully away and hold it in place.
(Fig. 9 - 4)
The attachment must not start to function until
the clutch lever has covered half the distance,
otherwise adjust the Bowden cable.
Switching off
3. Release the clutch lever. (Fig. 9 - 1)
The drive mechanism is switched off.
4. Release the clutch lever. (Fig. 9 - 4)
The attachment is switched off.
5. Set throttle to "STOP" position. (Fig. 11)
The engine is switched off.
Maintenance and care
Caution!
Risk of injury on sharp cutting tools.
Wear protective gloves!
Remove the spark plug connector before commencing
„
any maintenance or cleaning work!
Do not spray the machine with water! Water penetra-
„
ting the machine could cause it to malfunction.
Clean the machine after every use.
„
If the machine is left leaning to one side, the spark
plug must face upwards!
Locating bushing for attachments
Clean the locating bushing for attachments after every
„
use and grease with commercially available multipur-
pose grease. (Fig. 12)
Gears
Regularly check the oil level in the gearbox. The oil
„
drain plug screw is located on the gear casing, above
the wheel axle, on the same side as the petrol filling
connection of the engine. (Fig. 13)
Position the machine horizontally; support accordingly.
„
548977_i
Rotary tiller
„
Rotary sweeper
„
Push off spring connector on the wheel axle and re-
„
move the wheel.
Unscrew the oil drain plug screw.
„
Oil level: up to the lower edge of the filler hole; top up
„
gear oil if required.
Oil type:
Oil filling quantity:
Tyre pressure
2.25 bar
„
Adjusting the Bowden cables
a. Drive mechanism for attachments (without lock nut)
(Fig. 14)
b. Drive mechanism
1. Unscrew lock nuts.
2. Adjust the adjusting screw. (Fig. 15 - 2)
Care of the engine
Air filter
„
Spark plug
„
Oil change
„
Observe the operating instructions provided by the manu-
facturer of the engine.
Professional inspection required:
after collision with an obstacle
„
if an attachment is bent
„
in the case of damage to the gears
„
in the case of defective V-belts
„
GB
Gear oil SAE 80
approx. 0.50 l
15