Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
d ) Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
e ) Do not use a battery pack or appliance that
is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior resulting
in fire, explosion or risk of injury.
f ) Do not expose a battery pack or appliance to
fire or excessive temperature. Exposure to fire or
temperature above 266°F (130°C) may cause explosion.
g ) Have servicing performed by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the product is maintained.
WARNING: Do not attempt to modify or repair
the appliance
SAVE THESE
INSTRUCTIONS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz .......................hertz
min .....................minutes
or DC ......direct current
...................... Class I Construction
(grounded)
.../min ..............per minute
BPM ....................beats per minute
IPM .....................impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM ....................strokes per minute
A .........................amperes
W ........................watts
or AC ...........alternating current
ASSEMBLY
This model may be supplied with some of the
following accessories:
•
An accessory caddy for storing your accessories.
•
A crevice tool
10
for confined spaces.
•
Brush tool
for furniture and stairs.
11
Attaching The Accessory Caddy (Fig. B)
1. Place the edge of the charger base
the accessory caddy
2. Insert the brush tool
crevice tool
10
then push the crevice tool into the
accessory caddy.
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o .......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
8
on to the edge of
9
.
11
into the front of the
Fig. B
11
10
Attaching The Accessories (Fig. C, D)
Brush Tool
•
Insert the crevice tool
the appliance.
Make sure that it is pushed fully in. If the brush tool
required then insert the brush tool
crevice tool
.
10
Fig. C
10
11
Narrow Crevice Tool
•
Installation method of microscopic clearance nozzle
It can be used by attaching directly to the suction nozzle.
The super narrow crevice tool can be used to directly. Easy
to clean confined places, such as laptop keyboard gap.
Fig. D
12
English
9
10
into the front of
into the front of the
11
4
8
is
11
12
3
Publicité
Table des Matières
