Endress+Hauser RMA 422 Mise En Service page 63

Parameter
User code
User presettable operation
code.
An already set code can only be
changed if the old code is first
entered and the unit setting up
released. Then a new code can
be set up.
* Set point code
Set point changes require or
do not require a user defined
release code
This address is only active when a user defined operation code is set up.
Programme name
Display address:
Display of the software used
in the unit
Software version
Display address:
Display of the version
number of the software used.
Test
Test function for diverse
hardware components;
These are activated after the
component is selected.
Once this address has been left the unit automatically switches the address to
The red LED flashes during active test function!
Setting up selections
CODE
Value:
0000 to 9999
There is no operation
code active if "0" is set
LICOD
YES
Set points are user code
protected
NO
Set points can be
changed without setting a
user defined code
PNAME
SU-ID
TEST
OFF
None
REL1
Relay 1 is energised
REL2
Relay 2 is energised
DISP
All segments on the
numeric display and all
LEDs are activated for
approx. 5s.:
Energised relay means
rest position (yellow LED
on), in fault alarm and set
point infringement the
relay is de-energised.
Process transmitter
Default Actual
settings setting
0
YES
OFF
OFF
.
61