GÖLZ BS 400P Mode D'emploi Et Liste Des Pièces De Rechange page 28

BS 400P
5.3.1 Cutting method: Fixed depth cutting
In fixed depth cutting, the cutting head is locked in a
fixed position.
To do fixed depth cutting, please follow this procedure:

Switch off the machine and make sure the blade
is not rotating. (1)

Loosen the adjusting handle. (2)

Adjust the cutting head to the desired position.

Adjust the depth stop and tighten the counter
nut to fix it well.

Make sure the blade is not touching the table at
any position of the table.(3)

Tighten strongly the adjusting handle and make
sure the cutting head is well fixed and cannot
move. (4)

Put material on the table; adjust the position
using the back square. (5)

Start the machine. (6)

Put your left hand on the table pushing handle.
Put your right hand on the cutting head handle.
Your right hand should be ready to push the
emergency stop in case of any unexpected
problem. (7)

Push the table slowly and without undue
pressure towards the rotating blade.
1
3
5
7
2
4
6
- 28-
5.3.2 Cutting method: Free depth cutting for
multiple steps cutting
In free depth cutting, the cutting head is not locked in a
fixed position. This cutting method enables multiple
steps cutting which consists of moving the cutting head
back and forth with the material to be cut under the
rotating blade. For hard material, it is recommended to
use this cutting method (e.g. by doing many shallow
cuts).
To do free depth cutting, please follow this procedure:

Switch off the machine and make sure the blade
is not rotating. (1)

Loosen the adjusting handle (2)

Adjust the depth stop and tighten the counter nut
to fix it well.

Make sure the blade is not touching the table at
any position of the table when the cutting head is
at the lowest position. (3)

Put material on the table, adjust the position using
the back square. (4)

Start the machine (5)

Put your left hand on the table pushing handle.
Put your right hand on the cutting head handle.
Your right hand should be ready to push the
emergency stop in case of any unexpected
problem. (6)

Push the table slowly and without undue pressure
towards the rotating blade.

Use your right hand to adjust the depth while
cutting, Use your left one to slide the table back
and forth. (7)
1
3
5
2
4
6
5009001-00
BA-D-E-F-FL
®