Electrical Connections; Operation; Before Starting The Machine; Starting The Machine - GÖLZ BS 400P Mode D'emploi Et Liste Des Pièces De Rechange

BS 400P
17
4.6

Electrical connections

Before connecting the machine to a power supply,
make sure:

The voltage/phase supply corresponds to the
information indicated on the motor plate and
machine plate.

Available power
connection in conformity with safety regulations.

The size of the electric cable of the extended lead
is sufficient (H07RNF 3x2.5mm
230V)
5.

Operation

Attention: Location rid of anything
that might interfere with the opera-
tion! Ensure correct installation of
the blade! With the exception of the
operator, should be no other persons
present in the work area!
Warning: Never touch rotating parts!
5.1

Before starting the machine

Before starting observe the following points:
 Make sure that the blade is correct installed and
the blade guard is closed. The blade guard must
always be fitted when cutting.
 Defective or worn blades must be replaced
immediately.
 Make sure that the blade is not touching the cut-
ting table at any position of the cutting table or
cutting head.
supply must have
2
up to 50m for
 Fill the water tank with clean water and make sure
the water pump in completely immersed in the
water. The water pump doesn't run without water
refill the water tank with clean water if necessary.
 Supply cooling water to the blade by the water
pump.
 The material to be cut must not exceed the
following:
Weight < 10 kg - 22 lbs.
Max. Dimensions: 600 x 500 x 270mm – 23,6 x
19,7 x 10,6 in.
The machine only is operated in safe operating
condition!
Pay attention to the dispositions of cooling water and
flushing water as well as cutting muds. Cutting muds
must be absorbed, filtered and disposed of.
5.2

Starting the machine

ground
To start the machine, open the cover of the switch and
press the green button.
To stop the machine, press on the red button or
directly on the emergency switch to stop the machine.
After starting the machine check immediately the
following points:

The cooling water must be transported in
sufficient quantity from the water pump to the
blade. The water should drain on both sides of
the blade.

The water nozzles and water hoses should not
clog.
If one of these points is not correct, stop immediately
the machine!
The motor is equipped with a thermal protection to
prevent high temperature rises, if the thermal
protection triggers, wait until the motor has cooled
down before starting the machine again.
5.3

Cutting operation

Important: Observe all the previous
chapters in this manual, in particular
the safety and warning instructions!
Warning: Never touch rotating parts!
Attention: Transport the unit only
when the engine is stopped! This
applies also to a short change of
location!
Attention: Wear appropriate individual
protective equipment!
- 27-
®
5009001-00
BA-D-E-F-FL