Maintenance - Be Cool ZEUS Mode D'emploi

3d. Tighten the harness by pulling the strap (6), it
should fit the child snugly.
3f. Once the child is securely strapped in, you can
tilt the seat by pressing the lever (7) to the required
position.
Getting the child out of the seat.
To get the child out of the seat, you should first place
the seat in the loading position (2b).
Loosen the harness straps by pressing the
3e.
adjustment button.
Then unfasten the buckle and get the child out.
3a.
Please make sure that the child gets out of the
vehicle on the pavement side.
WARNING! Die straps should never be twisted.
The harness buckle must be fastened correctly and
the straps should fit the child snugly.

MAINTENANCE

Fitting / Removing the cover
The cover of the NADÓ O3+ seat is very easy to
remove. There are 2 fastening points for the cover on
the front. Unfasten these points and gently pull the
front part of the cover.
There are plastic parts on the sides of the cover used
to fasten it in place. Simply pull gently to remove
the cover.
To fit the cover back on, follow the same steps in
reverse. Insert the side parts in the slot.
Cleaning
The cover can be machine washed using mild
detergent and at a maximum temperature of 30º.
EN
31