Maintenance / Cleaning - Be Cool THUNDER iso-fix Instructions

GB
THUNDER iso-fix
5
DETACHING THE SEAT
To detach the seat follow the installation in-
structions in reverse. (it is advisable to give
yourself a bit more space by moving the front
seat forward as far as possible)
- First unfasten the headrest anchor (TOP
TETHER). F7
- Then unfasten the ISO-FIX, get inside the
vehicle facing the Thunder safety seat, then si-
multaneously raise the catches found on both
sides and gently pull outwards, until uncover-
ing the buttons on each side of the isofix leg
that display the status: GREEN (connected) or
RED (disconnected), press the green button
and pull the seat and the ISO-FIX anchor will
be disconnected, and then the seat is released.
F7.a - F7.b - F7.c
6 Adjusting the height of the shoulder belts
a) The correct height of the shoulder belts is
attained when the belt disappears into the
shell slightly above the shoulder of the child.
Ensure that the shoulder belts fit comfortably
over the child's shoulder. (Fig. 15)
b) Loosen the shoulder belts by pressing the
release button of the adjuster and pulling the
shoulder belts towards you as far as possible.
Important: Do not pull the belt pads when
doing so. (Fig. 9)
c) Place the shell of the seat in the sleeping
position.
d) Remove the shoulder belts from the yoke.
(Fig. 16-a)
e) Pull the shoulder belts through the belt
pads and belting slots in shell, ensuring that
the buckle remains fixed to prevent the belts
being twisted. (Fig. 17)
f) If you want to alter the belts from or to the
lowest positions, place the THUNDER to the
sleeping position.
g) If you want to alter the belts from or to the
higher positions, place the THUNDER to the
sitting position.
IM-1613.02 THUNDER isofix 30.7.15.indd 17
h) Place the shoulder pads at the expected
height and thread the shoulder straps back
through the shoulder pads, cover and shell.
(Fig. 18)
i) Connect the shoulder belts to the belt yoke.
(Fig. 19-a)
MAINTENANCE & CLEANING
General
a) The car seat can be cleaned by using luke-
warm water and soap. Do not use aggressive
cleaners like abrasives or thinner.
b)The cover should be washed by hand at a
maximum temperature of 30ºC. Do not put it
in the dryer.
c) It is advised to buy an extra cover when
purchasing the car seat that you can continue
using it when one cover is being washed.
Step 1: Take the car seat out of your car; en-
sure your entire baby's car toys are put away
before you begin cleaning it.
Step 2. Suck up food particles and dirt with
a cordless vacuum. If possible, use a port-
able vacuum cleaner's furniture attachment
to clean the small, hard-to-reach areas of the
car seat.
Step 3. Clean off the plastic portions of the
seat with gentle soap and water.
Step 4. Remove the entire car seat cover, if
possible, and run it through your washing ma-
chine gentle cycle.
Stpe 5. Spot clean the stained spots on the
car seat if you cannot remove the cover; make
sure you can use the soap on the car seat's
material by checking the package's guide-
lines.
Step 6. Reinstall the clean car seat in your car,
and take special care that all parts of the car
seat being present and installed safely and
correctly.
17
30/07/15 11:13