Publicité
Les langues disponibles
Les langues disponibles
Grating Disc
The grating disc can be used with the large or small bowls. The disc is reversible for fine or coarse grating.
1.
Fit the large bowl.
2.
Place the blade shaft onto the drive shaft (FIG N).
3.
If you are using the small bowl, fit it next (FIG F).
4.
Place the grating disc onto the blade shaft with the correct side up (small holes=fine, large
holes=coarse).
5.
Fit and lock the lid.
6.
Place the ingredients into the feed chute.
7.
Press the
button.
Use the pusher to press the ingredients down. Press Y / 2 to stop.
8.
9.
After use, unplug the appliance, open the lid and remove the disc.
•
Use light not heavy pressure when feeding ingredients.
Large Chopping Blade
1.
Fit the large bowl.
2.
Holding the blade as shown, carefully fit it onto the blade shaft (FIG P). Twist the shaft anticlockwise
to lock it. Take care—the blade is sharp!
3.
Place the assembled blade onto the drive shaft
4.
Place the ingredients into the bowl. Fit and lock the lid.
Press the desired button to start processing. Press Y / 2 to stop.
5.
6.
Ingredients can be added when the motor is running through the food chute.
7.
After use, unplug the appliance, open the lid and carefully remove the blade.
8.
To remove the blade, turn the shaft clockwise and carefully lift the blade off.
Small Chopping Blade
The small chopping blade is only used in the small bowl.
1.
Fit the large bowl.
2.
Place the blade shaft onto the drive shaft (FIG N).
3.
Fit the small bowl (FIG F).
4.
Carefully fit the small blade onto the blade shaft (FIG R).
5.
Fit and lock the lid.
6.
Add and process ingredients in the same was as for the large blade.
Dough blade
The dough blade is fitted and removed the same way as the large chopping blade. Only use the large
bowl and the
(LOW) speed button.
GENERAL TIPS
•
The processor works very quickly. Avoid over-processing foods.
•
Organize processing tasks to avoid multiple cleanups of the bowl; process dry before wet.
•
If food piles up on one side of the bowl, stop the processor and redistribute the food using a
spatula.
•
Do not process foods that are so frozen or hard that the tip of a knife cannot be inserted into the
food.
•
Processing nuts or other hard foods may scratch the surface finish of the bowl.
•
Do not overfill the bowl.
•
Process hot but never boiling liquids.
•
Remove seeds, core and pips/stones before processing fruits or vegetables.
•
Do not use the processor to grind coffee beans, bones, grains or hard spices, liquefy fruits and
vegetables, or slice/chop warm meat.
CARE AND MAINTENANCE
1.
Switch the appliance off and unplug it.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Wash all removable parts in warm soapy water, rinse well, drain, and air dry.
` You may wash these parts in a dishwasher.
6
Publicité
