Sonnenkonig ORBIT Mode D'emploi page 43

1.
2.
3.
4.
5.
Loosen the 2 screws on the side of the housing
[5] and remove the support plate [3] and turn it
counterclockwise to remove the plate from the
holder [6].
Feed the power cable [1] through the support
plate and attach the safety cable [2] to the
ceiling.
Attention: Please note that the installation
must withstand about 4 times the weight of the
fan.
Fasten the support plate to the ceiling with the
screws supplied. Choose between screws for
concrete and wood.
Connect the cables according to the diagram.
N = Neutral, L = Live(Phase),
If unclear, contact a specialist or the supplier.
Place the fan on the support plate and turn it
back into the holder. Make sure that any cables
are not pinched or protruding.
Now retighten the screws on the side of the
housing.
43
EN
= Ground.