Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
13. Tighten ALL fasteners to recommended torque specification
listed.
14. Install fairlead. Fairlead fasteners located in winch kit.
Plow Operation
1. Attach the push tube bracket (A3) to the plow blade
assembly.
NOTE:
The hardware for attaching the push tube assembly to
the plow blade assembly will be found in the hardware
kit that came with the plow blade.
NOTE:
The pin height should be approximately 14 1/2"
from the ground while plowing. For proper plowing
operation, adjust the spanner nut on the coil spring
adjusters on the vehicle to achieve ideal pin height.
2. Connect the termination strap (C2) to the front bumper. The
loop of the strap should be placed as high as possible on
the bumper.
©2012 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
7
Figure 13
A3
A3
14 1/2"
Figure 1
Figure 2
91256A0
Publicité
Table des Matières
