Warn 91257 Instructions D'installation page 6

9. Place grill (removed in step 3) back into position. Do not
fasten at this time because you may need to pull in and out
when securing bumper.
10. To allow for installation of the bumper, remove fasteners
that were temporarily placed in step 8.
11. Install bumper using fasteners previously removed in step
one. Tighten bumper fasteners to recommended torque
specification listed.
Secure grill at this time.
12. Install the two tube brackets removed in step one to
bumper and winch mount.
©2012 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
6
Figure 9
Remove
Figure 5
Figure 10
Long Bolt
Figure 11
Tube Brackets
Figure 12
91256A0