Troubleshooting - Klarstein 10032081 Mode D'emploi

EN

TROUBLESHOOTING

Under normal operation the system will hum due to the motor, impeller and cooling fan
in operation.
Grinding noise
The stainless steel skirt is loose. Push the stainless skirt up into the guide groove and turn
to the right until you hear a click. With the skirt secure, the noise will go away. There also
might be the chance the stirring shaft was inadvertently bent. If this is the case, unscrew
the bottom pump disk and gently push the impeller until it is centered.
Slurping noise
Your pump has formed a water vortex like when you are emptying out a bathroom sink
or tub. Add more water or gently disturb water with a spoon. There is no sure way to
eliminate a vortex from forming due to the pump rotation but usually will go away on its
own.
Gurgling and Woosh noise
The pump is sucking air - add more water. You should also see small bubbles in your
tank.
Food damage
The pump's water jet is cracking eggs or damaging fish fillets: Turn the pump outlet to
face the container wall; this will greatly temper the flow of the pump output. It is also
good practice to bag eggs to prevent them from being "blown" around in certain
containers.
System will not turn on
Check power plug and breakers.
Low water level alarm
Add more water – the water level can be dropped during operation by the pump due to
water turbulence.
15