Be Cool cabin Mode D'emploi page 17

TO UNFOLD AND ASSEMBLE
1 . Unfold the stroller frame (1 )Pull out the folding latch to release
the frame as Fig A; (2) Grip the handle and lift up to unfold the
stroller until hear the"click" sound. Check to make sure the
stroller is locked in the fully open position before using it.
2. To assemble bumper bar: Assemble: Align the bumper bar
pegs with holes in the front of seat unit and insert into until
hear clicks.
3. Disassemble: Press down both buttons on bumper bar and
pull out.
USE INSTRUCTIONS
4. To apply the brake: press the brake lever down. To unlock the
brake: lift the brake lever up. Always lock brake, make sure
brake is engaged by trying to push the stroller.
5. To adjust canopy: pull forward or press backward the canopy
wire to open or close canopy.
6. To assemble the Canopy: Press the canopy fixture onto the
handles in the direction of "B" Pull out the canopy fixture
directly to disassemble it.
7. To adjust backrest: To set upright position, push backrest
up with back of hand, hold the belt, grasp and push up the
adjustable buckle. To recline the backrest down, grasp and pull
down the adjustable buckle.
8. To use Restraint System: To unlock buckle, press in on center
button and pull harness out from each side. To buckle, push
each side of harness back into buckle until each clicks in place.
9. To adjust waist strap length: To shorten, pull bottom loop (2)
down, then pull on strap end (1). To lengthen, pull out top
loop(3), then pull out on buckle.
10. To adjust the footrest: As fig A, pull down the mental support
bracket on the back of footrest to extend. As fig B push up the
metal support bracket to not extend.
If the child is under 6 months, the chest straps must be
inserted into the lower holes of the backrest and then into the
lower holes of the padded mattress backrest.
11 . To fold stroller frame: 1) Fully open the canopy as Fig A);
2) Make the wheel in swivel mode, press down the small
button on the back of handle, at the sametime, squeeze the
folding button on hand and push forward the canopy to the
end until the frame is fully locked as Fig B; 3) Engage the
folding lock as Fig C.
EN
17