Publicité
Les langues disponibles
Les langues disponibles
Connection Fail
Power off & on
When the SETUP CARD is properly connected to the ESC, the screen below is shown.
Select Battery
LiPo
Sensor
If UP & DOWN buttons are simultaneously pressed, you can select motor type "S_less
Brush
S_less .....in order.
The following each selectable mode can be scrolled using UP or DOWN buttons. You can change any
parameters in the selected mode using INC or DEC buttons, and the changed parameter should be
blinking for 5 seconds.
Select Battery
Cut Off Voltage
Start Curr Limit
Neutral Width
Speed Mixing Brk
Brake Amount
Num
Gear Ratio
Load
Restore Memory
When selecting Down Load & Restore Memory & BACKUP Memory & Factory Setting modes, it shows
"Really?
If you press the INC button, it changes to " Processing " After its processing is completed,
If this processing is failed and some errors happen, "Connect Fail Power Off & On" should be shown
on the screen.
Error Message
Connection Fail
Power off/on
Power Curve
Current Limit
Current Voltage
Current Temp
Tire Diameter
Backup Memory
In case the device is not properly connected to the ESC, the screen above is
shown.
Advance Timing
Reverse Function
A.B.S Brake
Auto Brk Amount
Max Temperature
Maximum Speed
Factory Setting
Acceleration
Reverse Delay
M-Reverse Amount
Min Brake Amount
Max Current
Average Speed
Error History
Sensor
Start Power
Max
Motor Pole
Down
Publicité
