Proxxon KT 150 Manuel page 6

PROXXON Compound
X - Y table KT 150
Dear customer!
Please read and apply the following safety re-
gulations thoroughly before starting to work with
the equipment, thereby protecting yourself and
others.
Attention!
- Keep the working area clean and tidy.
- You should not wear jewellery, ties or wide
clothes when using the equipment with a
machine for drilling or milling. Loose clothes
can be caught by rotating parts and cause
serious injuries. Protect long hair with an ap-
propriate cover.
- Do not use the unit with a machine when you
are not feeling well, if you cannot concentrate
or if you are under the influence of alcohol.
- Keep children away from the working area.
- Fasten or clamp the work pieces securely.
- Check the machine for any obvious faults,
replace damaged parts.
- Do not route the mains cable through your
working area.
- Always wear goggles.
- Do not overload the machine.
- Always guide the work piece against the
cutting direction of the milling cutter.
- Clean the machine thoroughly after work.
- Keep unused tools in a locked room, out of
the reach of children.
- Use only accessories and spare parts which
are mentioned in these instructions or
recommended by the manufacturer.
Description of unit
The PROXXON Compound X - Y Table for milling,
drilling, routing of wood, plastics and metals.
The table can be mounted to any commercially
available drill stands without any problems.
Each ram is provided with a clamping device
with precisely milled dovetail grooves.
The ram is controlled by means of two spindles
with adjustable 0-position. One rotation is
identical with a feed of 2 mm, whereby one digit
an the scale equals 0.05 mm.
The guidings can be adjusted clearance-free.
90° and 45° fitting holes are provided for the
stop rail.
- 6 -
The work piece can be easily fastened to the
plane top of the table by means of a machine
vice or with clamping claws in the T-grooves.
Technical data
Working area:
Displacement range:
Height:
Weight:
Feed:
Fine adjustment of scale: 0.05 mm
Dimensions of T-grooves: Fig. 18
Operation
Installing the table
Secure and exact work is only possible when
fastening the table properly to the work top of
the drill stand.
Attention!
Always tighten the four fastening screws 4
(Fig. 2) when working with the compound table
mounted to your drilling stand.
1. Place the compound table onto the table of
the drill stand. Slide with T-grooves 1 (Fig. 2)
facing up, spindle (2) to the front and spindle
(3) to the left.
2. Wind spindle 3 (Fig. 2) to displace the slide
fully to the left. The right hand slotted hole is
now visible. Fasten the base with screws
M8x20 (4) to the drill stand.
3. Wind the spindle 3 (Fig. 2) to displace the
slide fully to the right. The right hand slotted
hole is now visible. Fasten the base with
screws M8x20 to the drill stand.
Installing the stop rail
1. Fasten the stop boards 1 and 2 (Fig. 3) to the
aluminium stop base by using the enclosed
countersunk screws (3).
Attention!
Screw the screw heads 3 (Fig. 3) completely into
the wood.
2. Fasten the protection 4 (Fig. 3) to the back
with two wood screws.
200 x 200 mm
max. 150 x 150 mm
75 mm
approx. 5.9 kg
2 mm per revolution
Note: