Lincoln Electric POWER MIG 140 Manuel De L'opérateur page 14

B-3
(See Figure B.3)
8. WELDING GUN CONNECTOR BUSHING &
THUMBSCREW – Provides electrical power to the
welding gun. The thumbscrew holds the welding
gun into the connector block. (Front of Machine,
Side Door and Wire Drive Cover have been
removed for clarity of Items 8 and 9).
9. OUTPUT TERMINALS –These connections allow
to change the welding polarity of the machine
depending on whether you are MIG welding or flux-
cored welding.
(See Figure B.4)
10. WIRE SPOOL SPINDLE AND BRAKE – Holds a
4"(102mm) diameter spool. Use the 2"(51mm)
spindle adapter included with the machine to use
8"(203mm) diameter spools. The thumbscrew sets
the brake friction to prevent the spool from over
rotating when the trigger is released.
(See Figure B.5)
11. WIRE DRIVE & COMPONENTS – Feeds wire
from the wire spool through the drive and through
the welding gun to the weld.
a. Top and Bottom Drive Roll – Drives the wire
through the drive system. The drive roll has a
groove to match the specific wire type and diam-
eter. Refer to Table B.1 for available drive rolls.
b. Inner & Outer Wire Guide – Guides the wire
between the Top and Bottom Drive Roll and
through the wire drive. The inner guide has a
groove to match a particular wire diameter.
Refer to Table B.1 for available wire guides.
c. Drive Roll Tension Thumbscrew – Turning
clockwise increases the force on the drive rolls
and turning counterclockwise decreases the
force.
OPERATION
POWER MIG® (140, 180 MODELS)
FIGURE B.3
8
9
FIGURE B.4
FIGURE B.5
TOP DRIVE ROLL PRESSURE ARM
TENSION ADJUSTOR DOWN
WIRE SPOOL
.035" (0.9mm)
NR-211-MP
INNER WIRE GUIDE REMOVED
LOWER DRIVE ROLL REMOVED
OUTER WIRE GUIDE REMOVED
B-3