Peavey Invective 120 Manuel D'utilisation page 12

MIDI IMPLEMENTATION
This amp is designed to be extremely functional with the included 10-button footswitch. The 8-pin footswitch
jack also works as a standard 5-pin MIDI input - to go along with the standard 5-pin MIDI output. There are
times when the amp will be run with other types of MIDI foot controllers, a PC in the studio, or by an automated
rack rig - or linked to another Invective via MIDI. This is the information you need to mate this amp with other
MIDI devices.
NOTE: The MIDI Out will send data to another Invective (for function sync), to a PC (for 2-way communica-
tion during remote control or preset dump), or to an effects unit in the effects loop. This jack does not act like an
Out/Thru. Data received at the MIDI In doesn't result in data on the MIDI Out unless it was a valid message for
this amp.
MIDI CC: MIDI Continuous Controllers are used to change one function at a time. After selecting a preset
(see below), modifications to that preset can be done with these messages. Making these changes on the amp or
footswitch generates these CC messages at the MIDI out.
Bn CC# data where n=chan-1
(Decimal)
1 01h
2 02h
3 03h
4 04h
* Amp doesn't respond to this, but it sends it based on preset/CC4 footswitch for controlling external MIDI gear.
5 05h
6 06h
7 07h
8 08h
9 09h
** Amp doesn't respond to this, but it sends it based on preset/Master Boost footswitch for controlling external
MIDI gear.
10 0Ah
11 0Bh
12 0Ch
13 0Dh
14 0Eh
15 0Fh
Example: B0 0A 7F enables master boost (MIDI chan 1)
12
(Hex)
Data: any
Select chan 1
Select chan 2
Select chan 3
Data: 00h-3Fh
*
Drive Boost 1 OFF
Drive Boost 2 OFF
Drive Boost 3 OFF
Drive Boost OFF
**
Master Boost OFF
FX Loop 1 OFF
FX Loop 2 OFF
Gate 2 OFF
Gate 3 OFF
Gate OFF
Data: 40h-7Fh
*
Drive Boost 1 ON
Drive Boost 2 ON
Drive Boost 3 ON
Drive Boost ON (active channel)
**
Master Boost ON
FX Loop 1 ON
FX Loop 2 ON
Gate 2 ON
Gate 3 ON
Gate ON (active chan, 2 or 3)