Publicité
Les langues disponibles
Les langues disponibles
V 4.0
6,500 lb Retractable Trailer Jack Quick-Stand Extension
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
Contents:
• Trailer Jack Extension • Quick-stand Head and Leg
• Square PTO Lock Pin • 2 in. Reducing Sleeve, 2 pc
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Dashed numbers in parenthesis (Fig. 1-1) refer to specific point of an
illustration or image.
TOOLS AND COMPONENTS REQUIRED
The following tools are needed to assemble and install the trailer jack:
• 9/16 in. Wrench x 2
• Wheel Chocks or Blocks
• Drill with 1/8 in. and 7/16 in. Drill Bits
INSTALLATION INSTRUCTIONS
The quick-stand extension fits over the end of your existing jack. You may need
to drill holes in the jack's extension tube if it is too small or doesn't have
existing holes to attach the quick-stand. You must drill holes in the quick-
stand's extension leg if you shorten it.
The jack must have a removable foot as the extension replaces it.
1.
Park the trailer on a level surface and chock or block the trailer wheels.
2.
Place Jack stands under the trailer's front frame or
behind the trailer coupler. Check that the trailer is
secure and will not move during installation.
3.
Fully retract the jack cylinder. The bottom of the
cylinder must be 13 in. above the ground for
installation (Fig. 1-1).
4.
Remove the foot (Fig. 1-2) from jack's extension tube.
5.
Drilling is required if the jack cylinder's bolt hole is too narrow or if it does
not have one (see Drilling Holes for the Quick-Stand).
Visit www.princessauto.com for more information
• Tape Measure
• Pencil, Pen or Marker
8655730
• Base Plate
• Hardware
• Jack Stands
• Center Punch
Fig. 1
5
Publicité
