Removing The Sim Card; Electrical Connections - MVG Neptu Link Manuel Utilisateur

Inserting a second SIM card:

REMOVING THE SIM CARD

Follow the steps below to remove either of
the SIM cards from your terminal.
Switch the device off.
➊
Unscrew the center cover.
➋
Push in then release the SIM card to remove
➌
it from the slot.
Screw the cover back on.
➍
Switch the device back on.
➎
Never remove the SIM card when
the terminal is switched on,
as this may damage the card and/or
the terminal.

ELECTRICAL CONNECTIONS

The terminal can be powered in two ways:
• Power supply through the 12-24 V DC
socket.
• 24 VDC Power over Ethernet (PoE) connec-
tion using a passive injector.
Stay at least 20 cm away from
the terminal when it is switched on.
If you have the PoE option, do not connect
the PoE injector and the standard
power supply at the same time.
For passive PoE power supply,
do not connect/disconnect the power
cable when the injector is on.
Before installing the terminal blocks and plug-
ging in, the cable(s) used must be threaded
through the cover's grommet (one cable per
gland).
The grommets are delivered unpierced. The
cable must be pushed through to open the
grommet at the center. When using PoE, do
not puncture the unused grommet.
EN
9