Appendix; Configuring Your Computer For Dhcp - MVG Neptu Link Manuel Utilisateur

Appendix

This Appendix contains links to reference
documents explaining the technologies that
your terminal uses:
Document Link
Technical features NeptuLink_Datasheet_EN.pdf
Configuring your computer
for DHCP
To access your terminal, you will need to use
the DHCP (Dynamic Host Configuration Proto-
col). Your terminal will contact a DHCP server,
which automatically assigns an IP address to
the computer connected to the Ethernet port.
To activate DHCP, follow the steps below:
Click Start , then Control Panel and
➊
Network and Sharing Center.
To display the network connections, click the
➋
Change card settings link on the left-hand
side of the Network and Sharing Center
panel.
Right-click the connection you wish to
➌
change, then click Properties
an administrator password or confirm the
change if prompted to do so.
Click Internet Protocol version 4 (TCP/
➍
IPv4) then Properties.
Illustration 1: Network Connection
Properties dialog box.
Click Obtain an IP address automatically.
➎
Click Obtain DNS Server addresses auto-
➏
matically.
. Enter
Illustration 2: Internet Protocol version
4 (TCP/IPv4) Properties dialog box.
Click OK to close the dialog box. Your com-
➐
puter is now configured for DHCP.
EN
17