Prerequisites; Required Sim Configuration; Getting Started; Inserting The Sim Card - MVG Neptu Link Manuel Utilisateur

Prerequisites

Ensure that you have the following items
ready before installing your terminal:
• Active Internet access from a telephone
service provider (3G/4G data package).
• Configuration settings for the SIM card(s) -
see below.
• Computer configured for DHCP (Dynamic
Host Configuration Protocol, see appendix).

REQUIRED SIM CONFIGURATION

Depending on how your SIM card(s) are
configured, you will need one or more confi-
guration settings to connect your terminal
to the Internet:
• APN setting (Access Point Name).
• PIN code (Personal Identification Number).
Your telephone service provider should have
given you all the necessary information to en-
able you to connect to the Internet. Please
contact your service provider if you cannot find
this information.

Getting started

Your terminal can be configured in five steps:
Insert the SIM card(s).
➊
Connect the terminal.
➋
Install the terminal on its mounting.
➌
Configure the terminal.
➍
Connect to internet.
➎
Ask your telephone service provider for your
SIM card's configuration settings before you
start.
8
Ensure that you check the network
coverage and compare the offers
available from different service
providers.
Stay at least 20 cm away from
the terminal when it is switched on.

INSERTING THE SIM CARD

Follow the steps below to insert either of
the SIM cards into your terminal.
This terminal is designed to accept one
or two Mini SIM card.
Using an incompatible SIM card may
damage your terminal or your card.
Switch the device off.
➊
Unscrew the center cover to access the
➋
SIM card slots.
Insert the SIM card into its slot. The chip
➌
must be positioned with its cut-off edge
facing towards the terminal, as shown in
the figure below. When using only one chip,
insert it in the slot marked "1".
Screw the cover back on.
➍
Switch the device back on.
➎