Klarstein MIDNIGHT SUN Mode D'emploi page 26

EN
26
Setting the temperature
Press the UP or DOWN button to set the target temperature. If you have set a weekly
timer, you can also adjust the temperature manually. However, this will be overwritten
with the programmed target temperature when the next heating period starts.
Select heating mode
Press and hold the MODE button for 3 seconds to select SMART mode or TIMER ON/
OFF mode. When you turn on the remote control for the first time, the display shows OFF
for both modes.
• TIMER ON/OFF means that the programmed timer and temperature settings of 1-5
(Monday-Friday), 6 (Saturday) and 7 (Sunday) are turned ON or OFF. Symbols
1-5, 6 and 7 are shown at the bottom of the mode display.
• SMART ON means that the remote control calculates the temperature difference
between the room and the target temperature 3 hours before the programmed start
time and decides by how much earlier the heating must be switched on to reach the
target temperature on time.
• The SMART MODE has a monitoring function that detects open windows. If open
windows are detected, the heating is automatically switched off or on if the room
temperature continuously drops or rises above 1.5 °C within 3 minutes.
SET button
With the SET key you can set the weekly timer and temperature, intelligent adaptive start
time and FAV temperature. To do this, press and hold the SET button for 3 seconds.
Note: A completed setting does not automatically start the heating. The heater will
not be turned on until the on timer is active.
Setting the weekly timer
First set the time for switching the heating on and off for days 1-5 (Monday-Friday).
Press HIGH to set the hour for the timer and DOWN to set the minutes for the timer (15
minutes per press). Then press SET to save the setting and adjust the temperature. When
you are finished, press SET to make the settings for 6 (Saturday) and 7 (Sunday) in the
same way. Finally, press SET again to save the settings.