Mounting On The Ceiling - Klarstein MIDNIGHT SUN Mode D'emploi

MOUNTING ON THE CEILING

Note: Installation and power connection must be carried out by a qualified
electrician!
1. Mark the mounting holes on the ceiling (where the power cable comes out of the
ceiling) and drill into the ceiling at the marked points. Then insert the plugs into the
ceiling.
2. Wire the LED light input cable to the power cable in the ceiling and wrap the
connection with waterproof insulating tape (supplied) or other suitable insulating
tape There are 3 wires inside the LED Light Input Cable (live wire, neutral wire &
ground wire). Make sure to connect the appropriate lines (live wire to live wire,
neutral wire to neutral wire, ground wire to ground wire).
Note: Never hang the heater from the LED power input cable or the heater power
cable on the ceiling.
Ground wire (yellow-green)
Neutral wire (blue)
Live wire (brown)
EN
21