EN
28
IMPORTANT NOTES ON OPERATION
• One remote control can be connected to several receivers at the same time and thus
operate several heaters.
• All settings must be reset after changing or removing the batteries.
• To use the weekly timer, make sure that the TIMER function has been switched to
ON by pressing the MODE button for a long time. If you prefer to operate the
heater manually, make sure that the TIMER function is set to OFF.
• Do not cover or touch the temperature sensor located on the top of the remote
control.
• Leave the remote control open in the room, do not put it in a drawer or bag, under
a pillow or blanket.
• Replace all batteries with new ones immediately when the battery symbol flashes
on the display, otherwise the remote control will not be able to control the heater.
• Remove the batteries from the remote control if you are not going to use it for a long
time.
• Please unplug the receiver from the power outlet if it will not be used for a long
period of time.
CLEANING AND CARE
Note: Turn off the unit and unplug it from the power outlet. Wait until the unit has
completely cooled down before cleaning it.
• Use a vacuum cleaner to clean the ventilation slots and grilles.
• Remove dust on the outside surfaces with a damp (not wet) cloth.
• Do not use strong cleaning agents or abrasives.
• Do not spray the device with liquids or immerse it in water or other liquids.
• Never open the heater housing.